MPX Connector Solder PCB - 6 Pins
SKU:
£5.99
£5.99 - £9.99
This small circuit board is used to make it easier and tidier to solder wires to Multiplex (MPX) plugs and sockets. The circuit board is soldered to the connector and the wires are then soldered to the board; no gluing is necessary. For isolation use suitable heat shrinkable tube.
The center pins of the 6 pin variant are not merged, here in total 6 electric seperated contacts lead to 8 soldering pads. (Both center pins of the 4 pin variant are merged on the PCB. So in total 4 electric separated contacts lead to 8 soldering
pads). Soldering of servo cables to the top side and the bottom side of the PCB is possible.
PCB only packs contain 5 PCBs. Connector sets include 4 PCBs, 2 plugs, 2 sockets, heatshrink and tie wraps.
The center pins of the 6 pin variant are not merged, here in total 6 electric seperated contacts lead to 8 soldering pads. (Both center pins of the 4 pin variant are merged on the PCB. So in total 4 electric separated contacts lead to 8 soldering
pads). Soldering of servo cables to the top side and the bottom side of the PCB is possible.
PCB only packs contain 5 PCBs. Connector sets include 4 PCBs, 2 plugs, 2 sockets, heatshrink and tie wraps.